3104387 Valve Cover for 2007 CUMMINS ISX15 DOHC Diesel Engine with Chrome Cover. OE/OEM Part Number: 3104387. Valve Cover for 2007 CUMMINS ISX15 DOHC Diesel Engine. Due to the color difference of the display, the received items may be a little different from the color on the picture, please know in advance! YOU MAY ALSO LIKE. Brand New 3687069 OEM 2013 Cummins ISX15 Diesel Engine with Rubber Gasket. 3104392 Valve Cover Gasket for Cummins ISX/QSX Engine 15 Liter. Brand New Cummins ISX15 Diesel Engine Front Timing Gear Cover 3687068. Brand New 3104387 OEM for 2007 CUMMINS ISX15 DOHC Diesel Engine Valve Cover. Lower 48 states with physical address. An 5% additional charge will be apply on American Express users. Parts must be in new, re-salable condition. If a part arrives damaged, or is defective, we can help you to take care of it but it must be reported to us immediately. Please be patient if your inquiry requires further investigation. Business Hour: 8:30am – 5:00pm Monday through Friday. Once you have received your item, please leave feedback for us as this will inform us that you have received your items. When re-installing the turbo, be sure that you take out any rags anything else you used to block off any inlets or intercooler hoses. Your old turbo’s Demise. But if you killed a fairly new turbo for no apparent reason, think about what could have been the cause of the turbo’s failure. If you simply bolt on a new turbo without fixing the problem, don’t expect your new turbo to live long either. The Shaft is Rocky. There is a gap between the shaft and sleeve and a gap between the sleeve and housing. These two gaps combined allow the compressor wheel tip to move side to side in what may look like an alarming amount. As long as the wheel is not touching the housing, you are fine. There should be no play axially (in and out) with the compressor wheel and shaft. You were doing some grinding or porting near the motor with the turbo removed. You blocked off the turbo oil drain pipe with a piece of tape. You forget to take the piece of tape and install the turbo. Start it up and instant James Bond smoke. The oil flow into the turbo has nowhere to go and gets pumped out the bearing seals. If your turbo does this, check the oil drain for blockage, remove it and start it up again. The turbo will be fine, it will take a few minutes of driving to burn out all the oil from the exhaust system. Also a plugged up crank case vent will cause excessive pressure to build up in the crankcase. This prevents the oil from draining out of the turbo and blows the excess oil out through the turbo seals. Add to Favorite Sellers. Please give us five-star feedback, if you accept our products and services, thank you very much!